Electric gates, railings and security fencing in Milton Keynes
Milton Keynes is one of the few places on our patch where all three sides of what we do get used equally: commercial gates and barriers on the distribution parks, security fencing on industrial and utility sites, and driveway gates and railings on the residential side.
Gates, fencing and railings in Milton Keynes
Milton Keynes was laid out around a grid of roads, and everything about working there follows from it. Sites are large, set back behind their own access roads, and served by their own entrances rather than by a shared street. That means the entrance is usually the whole security arrangement rather than one part of it: a vehicle gate, a barrier, a run of perimeter fencing, and access control that has to work for staff, deliveries and contractors from the same credential.
The distribution and warehousing sector is the largest single source of that work. Those sites cycle their gates and barriers constantly, they have long perimeters, and their entrances cannot be closed while somebody investigates a fault. Alongside them, the utilities, compounds and industrial estates bring the security fencing work: welded mesh, 358 and palisade, with the gates in the line made and automated by us rather than bought in and adapted.
The residential side is spread across the older towns and villages absorbed into the city, Bletchley, Wolverton, Stony Stratford and the surrounding villages, where the property is older and the frontages take railings and gates.
Typical jobs in Milton Keynes
Perimeter fencing with gates in the line
Welded mesh, 358 and palisade fencing on industrial, utility and construction sites, with the vehicle and pedestrian gates made in our workshop and automated as part of the same job.
Gate and barrier maintenance on distribution sites
Planned maintenance and reactive call-outs on any make, with a documented job report every visit and same day emergency response where the entrance is blocked.
Driveway gates and railings on older property
Gates made to the opening and railings made to the run, in the older towns and villages across the city.
Local questions
Do you do the fencing and the gates, or just the gates?
Both, and they are usually better done together. There is little point specifying a serious perimeter fence and then leaving a gate in it that anybody can push open. We make the gates in our own workshop, install the fence line, and wire the access control into the same system.
Can you make railings to match what is already on the house?
We make to a drawing and to a site measurement rather than fitting standard panels, so a run can be made to suit an existing frontage or a pattern already on the property. Send a photograph when you enquire and we will tell you what is involved.